Solar panels on period and Arts and Crafts homes

An Arts and Crafts house, a Victorian villa or a listed cottage can often still have solar panels. The question is usually where they go and how they look, not whether they are possible at all. This guide covers the options most often used on older homes in Surrey and Berkshire, and the questions to ask an installer.

Last reviewed 21 October 2026. Sources are listed at the end of this page.

SLATE OR CLAY TILEPV · OUTBUILDING ROOFSIDE ELEVATION · PERIOD HOME AND GARAGE · NOT TO SCALE

What makes homes here different

Arts and Crafts houses

Surrey has some of the best-known Arts and Crafts architecture in the country, by architects including Edwin Lutyens and Charles Voysey. These homes often have large, steep, highly visible roofs, which are part of what makes them special.

Clay tile roofs

Many older Surrey and Berkshire homes are roofed in clay tiles, sometimes handmade, and some have tile-hung walls. Old clay tiles can be brittle, so fixing panels to them takes care.

Slate roofs

Victorian and Edwardian homes, common in towns such as Windsor, Guildford and Newbury, often have slate roofs, which need their own fixing methods.

Heritage protection

Many homes are listed or sit in a conservation area, the Surrey Hills or the North Wessex Downs. Our planning guide explains what each of these means.

Where panels usually sit best

On older homes, the less a panel is seen, the easier the case tends to be. Historic England’s advice for listed buildings follows a similar order, and it’s a useful guide for unlisted period homes too:

1. A rear or less prominent roof slope

Historic England says panels on less prominent slopes will generally be acceptable on a listed building, even if they would be visible.

2. A valley roof, or a flat roof behind a parapet

These locations normally have very little impact.

3. An outbuilding

A garage, stable or workshop can carry panels without touching the main house, provided it isn’t more prominent than the house. A 2025 application in Guildford sought consent for exactly this, on a detached garage beside a listed home.

4. The ground

Panels in the garden avoid the roof altogether, though they still need care in the setting of a listed building. Many homes here have the large gardens this needs.

5. The main roof slope facing the street

This is usually the hardest case, and on a listed building Historic England says panels will generally not be acceptable there.

Clay tile and slate roofs

Most panels are fixed with brackets that pass between or through the roof covering to the rafters below. On an older roof, a few things are worth asking about:

• Clay tiles. Some tiles usually have to be lifted, cut or replaced around each bracket. Ask whether the installer can match any tiles that break, and where replacements will come from. Handmade tiles can be hard to match.

• Slate. Slate roofs need fixings designed for slate, with flashing to keep each bracket watertight. Ask what system they use and who repairs any slates broken during the work.

• Tile-hung walls. Panels on a wall have their own planning limits, and on a tile-hung wall the fixing is harder still. A roof or the ground is usually simpler.

On-roof, in-roof or solar tiles

Option

How it looks

Things to weigh

On-roof panels

Panels sit on rails a few centimetres above the existing roof covering.

Usually the simplest and cheapest option. The brackets have to pass through the roof covering, which needs care on old clay tiles or slate.

In-roof panels

Panels replace part of the roof covering and sit roughly flush with it.

A lower, neater profile that some councils prefer. Usually costs more, and part of the roof covering is removed. Easiest during a re-roof.

Solar tiles or slates

Small solar units laid in place of tiles or slates.

Historic England says they don’t usually look convincingly like traditional slates, so they may suit only slopes of low visibility, ideally during a re-roof.

Ask your installer which options suit your roof. Not every installer fits in-roof systems or solar tiles, and not every roof suits them.

Making panels less noticeable

Epsom and Ewell Borough Council’s guidance on domestic solar makes points that apply well beyond Epsom:

• Choose panels and frames that blend with the colour of the tiles or slates. Against dark tiles or slate, that usually means all-black panels with black frames.

• Use a rear or less prominent slope where you can, even if it generates a little less.

• Keep the array a regular, preferably symmetrical, shape, and don’t run it to the edges of the roof.

• Consider in-roof panels if you are re-roofing anyway, because they sit flatter.

• In a deep garden, consider ground-mounted panels screened by low planting.

The guidance dates from 2011, so treat it as general design advice and check your own council’s current position. The same council also notes that some of its conservation areas have no permitted development rights for solar panels at all, which is a reminder to check for Article 4 directions.

The roof itself

Panels usually last 25 years or more, so the roof under them needs to last too.

Condition

If your roof will need work in the next few years, it can be worth doing that first, or combining the two jobs to share scaffolding.

Weight

Historic England says the extra weight of panels on a historic roof needs specialist consideration. Ask your installer whether they will check the roof structure.

Fixings

Ask how the brackets will be fixed, how any tiles or slates removed will be put back, and who repairs any broken during the work.

Weather-tightness and fire risk

Historic England also lists these as points to consider on historic roofs.

Listed homes

Listed building consent is always required for solar panels on a listed building, and doing the work without it is a criminal offence. Historic England’s 2024 advice note covers solar in some detail:

• Panels on less prominent slopes will generally be acceptable, even if visible.

• Valley roofs and roofs behind parapets normally have very little impact.

• Outbuildings or land within the grounds are generally preferable to the main building.

• Grade I and Grade II* buildings may be exceptions, where even less prominent slopes may not be suitable.

It’s worth asking your council for pre-application advice before you apply. A fee may apply.

Questions to ask an installer about a period home

• Have you worked on clay tile or slate roofs, or listed buildings, before, and can I see examples?

• Which slope or location would you recommend, and why?

• Do you offer all-black panels, and in-roof systems if they would suit?

• Will you check the roof structure and condition before quoting?

• How will you fix the panels, and how will you deal with any broken tiles or slates?

• Will you help with the planning or listed building consent application?

FIND OUT MORE ABOUT SOLAR IN YOUR AREA

GOOD QUESTIONS. CLEAR ANSWERS.

Frequently asked questions

A few things worth knowing before you start.

GET STARTED

Own a period or listed home?

Tell us about it and we’ll introduce you to MCS-certified installers serving your area. Mention that your home is listed or in a conservation area, so they can check the options before quoting. There is no cost to you and no obligation.

Free, no-obligation introduction to MCS-certified installers.Check if solar suits my home

Surrey Berkshire Solar

A local connection for a brighter home.

© 2026 Surrey Berkshire Solar. An introduction service, not an installation company. All quotations and installation contracts are agreed directly with your chosen installer.

Surrey Berkshire Solar is a trading name of Paul Lau, Office 22420, 182-184 High Street North, East Ham, London E6 2JA. Contact: contact@surreyberkshiresolar.co.uk